Monday, August 15, 2011

Netapp : How to restore data from aggregate snapshot


          Today one of our user found himself in wet pants when he noticed his robocopy job has overwritten a folder, rather than appending new data to it. Being panicked he run to me looking for any tape or snapshot backup of his original data, which unfortunately wasn't there as previously he confirmed that they don't need any kind of protection.

Now at this time I had only place left where I can recover the data, aggregate level snapshots; so I looked at aggregate snapshots and saw it goes back to time when he had data in place. Knowing that the data deleted from volume is still locked in aggregate's snapshot I was feeling good that I have done a good job by having some space reserved for aggregate level snapshot, which no one ever advocated.


Now the next step is to recover the data, but problem was that if I revert aggregate using "snap restore –A" then all the volumes in that aggregate will be reverted which will be bigger problem. So had to go on a different way, use aggregate copy function to copy the aggregate's snapshot to an empty aggregate and then restore the data from there.


Here's the cookbook for this.


Pre-checks:


  • The volume you lost data from is a flexible volume
  • Identify an aggregate which is empty so it can be used for destination (could be on another controller also)
  • Make sure the destination aggregate is either equal or larger than source aggregate
  • /etc/hosts.equiv has entry for the filer you want to copy data to and /etc/hosts has its IP address added, in case of copying on same controller loopback address (127.0.0.1) should be added in /etc/hosts file and local filername should be in hosts.equiv file
  • Name of aggregate's snapshot which you want to copy


Example:

Let's say the volume we lost data was 'vol1', the aggregate which has this volume is 'aggr_source', the aggregate's snapshot which has lost data is 'hourly.1' and empty aggregate where we will be storing data to is 'aggr_destination'


Execution:


  • Restrict the destination aggregate using 'aggr restrict aggr_destination'
  • Start the aggregate data copy using 'aggr copy start –s hourly.1 aggr_source aggr_destination'
  • Once the copy is completed online the aggregate using 'aggr online aggr_destination'
  • If you have done copy on same controller, system will rename the volume 'vol1' of 'aggr_destination' to 'vol1(1)'
  • Now export the volume or lun and you have your all lost data available.
So here's the answer to another popular question, why do I need to reserve space for aggregate level snapshot. Do you have the answer now?

No comments:

Post a Comment



Follow storageadmiins on Twitter Follow storageadmiins on Twitter